Rancang Bangun Dispenser Minyak Goreng dengan Flowmeter Mekanik Dilengkapi dengan Micro SD dan RTC Berbasis Mikrokontoler Atmega328
View/ Open
Date
2021Author
Margolang, Anggi Rizkia
Advisor(s)
Brahmana, Kurnia
Metadata
Show full item recordAbstract
A cooking oil dispenser with a mechanical flow meter based on
ATMega328 has been made. This tool uses a mechanical sensor, Microcontroller
ATMega328, MikroSD / RTC, Power Supplay, Solenoid Valve, and Display Oled.
This tool is used as a water volume regulator. From the oil container, the liquid
will go to the flowmeter. Inside the flowmeter output will provide a value / pulse,
then the value / pulse will enter the microcontroller. Then the incoming data will be
in accordance with the settings made on the analog keypad. The value / pulse will
be set at 100cc, then when it is 100cc the microcontroller will give a signal to the
solenoid valve which functions to help close the valve, because it has the correct
dosage. The liquid will be collected in the container bottle. Then the signal will be
converted from a small signal to a large signal in the driver. Then the test data will
be stored in the MicroSD / RTC, and the results of the output will be displayed on
the display. Telah dibuat sebuah alat dispenser minyak goreng dengan flowmeter mekanik
berbasis ATMega328. Alat ini menggunakan sensor mekanik, Mikrokontroler
ATMega328, MikroSD/RTC, Power Supplay, Solenoid Valve, dan Display Oled.
Alat ini dimanfaatkan sebagai pengatur volume air. Dari kontainer minyak, cairan
akan menuju flowmeter. Di dalam output flowmeter akan memberikan nilai/pulsa,
kemudia nilai/pulsa tersebut masuk ke dalam mikrokontroler. Maka data yang masuk
tersebut akan sesuai dengan setting yang dibuat di keypad analog. Nilai/pulsa akan di
setting 100cc, maka ketika telah 100cc mikrokontroler akan memberikan sinyal
terhadap solenoid valve yang berfungsi untuk membantu menutup katup karena telah
sesuai takaran. Cairan akan ditampung di botol penampung. Selanjutnya sinyal akan
dikonversi dari sinyal kecil menjadi sinyal besar di driver. Kemudian data dari
pengujian akan tersimpan di MicroSD/RTC, dan hasil dari output akan ditampilkan
di display.
Collections
- Undergraduate Theses [1324]